This feature is not necessary anymore since we have tools like valgrind today
that can catch stack overflow errors before they make a backtrace in gdb
impossible.
In light of the recent improvements of attacks on SHA1, the default hash
algorithm in tinc is now SHA256. At the same time, the default symmetric
encryption algorithm has been changed to AES256.
PMTUDiscovery was disabled in commit d5b56bbba5
because tinc did not handle packets larger than the path MTU in switch and hub
modes. We now allow it again in preparation of proper support, but default to
off.
Instead of a single, global decryption context, each node has its own context.
However, in send_ans_key(), the global context was initialised. This commit
fixes that and removes the global context completely.
Also only set status.validkey after all checks have been evaluated.
In preparation of chroot/setuid operations, split out call to
try_outgoing_connections() from setup_network_connections()
(which was the last call in setup_network_connections()).
This is because dropping privileges should be done in-between
setup_network_connections() and try_outgoing_connections().
This patch renames setup_network_connections() to setup_network()
and moves call to try_outgoing_connections() into main routine.
No functional changes.
Previously, tinc used a fixed address and port for each node for UDP packet
exchange. The port was the one advertised by that node as its listening port.
However, due to NAT the port might be different. Now, tinc sends a different
session key to each node. This way, the sending node can be determined from
incoming packets by checking the MAC against all session keys. If a match is
found, the address and port for that node are updated.
In switch and hub modes, tinc does not generate ICMP packets in response to
packets that are larger than the path MTU. However, if PMTUDiscovery is
enabled, the IP_MTU_DISCOVER and IPV6_MTU_DISCOVER option is set on the UDP
sockets, which causes all UDP packets to be sent with the DF bit set, causing
large packets to be dropped, even if they would otherwise be routed fine.
Previously an outgoing_t was maintained for each outgoing connection,
but the pointer to it was either stored in a connection_t or in an event_t.
This made it very hard to keep track of and to clean up.
Now a list is created when tinc starts and reads all the ConnectTo variables,
and which is recreated when tinc receives a HUP signal.
