SDK3.5
This document shows Ameba SDK 3.5 APIs
|
This file provides mbed API for UART. More...
Ameba Common | |
enum | SerialParity { ParityNone = 0, ParityOdd = 1, ParityEven = 2, ParityForced1 = 3, ParityForced0 = 4 } |
UART Parity mode used by serial_format. More... | |
enum | SerialIrq { RxIrq, TxIrq } |
UART Interrupt enable/disable used by serial_irq_set. More... | |
enum | FlowControl { FlowControlNone, FlowControlRTS, FlowControlCTS, FlowControlRTSCTS } |
UART FlowControl mode used by serial_set_flow_control. More... | |
typedef void(* | uart_irq_handler) (uint32_t id, SerialIrq event) |
typedef struct serial_s | serial_t |
void | serial_init (serial_t *obj, PinName tx, PinName rx) |
Initializes the UART device, include clock/function/interrupt/UART registers. More... | |
void | serial_free (serial_t *obj) |
Deinitializes the UART device, include clock/function/interrupt/UART registers. More... | |
void | serial_baud (serial_t *obj, int baudrate) |
Set UART device baudrate. More... | |
void | serial_format (serial_t *obj, int data_bits, SerialParity parity, int stop_bits) |
Set UART format. More... | |
void | serial_irq_handler (serial_t *obj, uart_irq_handler handler, uint32_t id) |
Set UART interrupt hander if needed. More... | |
void | serial_irq_set (serial_t *obj, SerialIrq irq, uint32_t enable) |
Enable/Disable UART interrupt. More... | |
int | serial_getc (serial_t *obj) |
get one byte from UART. More... | |
void | serial_putc (serial_t *obj, int c) |
send one byte use UART. More... | |
int | serial_readable (serial_t *obj) |
check if there is data in rx fifo. More... | |
int | serial_writable (serial_t *obj) |
check if write data to tx fifo is permitted. More... | |
void | serial_clear (serial_t *obj) |
Clear Rx fifo. More... | |
void | serial_break_set (serial_t *obj) |
enable UART break contol function. More... | |
void | serial_break_clear (serial_t *obj) |
disable UART break contol function. More... | |
void | serial_pinout_tx (PinName tx) |
set tx pinmux. More... | |
void | serial_set_flow_control (serial_t *obj, FlowControl type, PinName rxflow, PinName txflow) |
uart autoflow contol setting. More... | |
This file provides mbed API for UART.
mbed Microcontroller Library
Copyright (c) 2006-2013 ARM Limited
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.