initial commit

project/realtek_amebaz_va0_example/example_sources/gspi/readme.txt

@@ -0,0 +1,45 @@
+Example Description
+
+	This example describes how to communicate with AmebaZ gspi interface. 
+
+How to build:
+	1. copy src\main.c to project\realtek_amebaz_va0_example\src
+
+	This example source code(mian.c) contain both GSPI slave code and SPI master code, you can use "CONFIG_GPSI_SLAVE" to choose which dirver to run.
+
+	"#define CONFIG_GPSI_SLAVE 1"  for GSPI Slave
+	"#define CONFIG_GPSI_SLAVE 0"  for SPI master
+
+Requirement Components:
+    2 AmebaZ Board
+
+    AmebaZ (A): Assign as SPI master
+	
+	SPI0_MOSI : PA_23
+	SPI0_MISO : PA_22  
+	SPI0_SCLK : PA_18
+	GPIO_CS : PA_28
+	GPIO_INT : PA_27
+
+    AmebaZ (B): Assign as GSPI slave
+
+	GSPI_MOSI :	PA_20
+	GSPI_MISO : PA_22
+	GSPI_CLK : PA_21
+	GSPI_CS : PA_19
+	GSPI_INT : PA_23
+
+Setup:connect A and B as given
+	
+	A:	            B:
+	SPI0_SCLK  ---  GSPI_CLK
+	GPIO_CS    ---  GSPI_CS
+	SPI0_MOSI  ---	GSPI_MOSI
+	SPI0_MISO  ---	GSPI_MISO
+	GPIO_INT   ---	GSPI_INT
+	V3.3       ---  V3.3
+	GND        ---  GND
+
+Behavior:
+	A send 2048 bytes to B about every 500ms and B will send whatever received back to A.
+	Every time if A Checks Rx Datas are the same as Tx Datas,then it logs "Succeed" ,else it logs "Failed" and finished.