open-ameba/sdk/component/common/mbed/hal/sleep_api.h

65 lines
2.2 KiB
C
Raw Permalink Normal View History

2016-11-09 00:56:41 +00:00
/* mbed Microcontroller Library
* Copyright (c) 2006-2013 ARM Limited
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef MBED_SLEEP_API_H
#define MBED_SLEEP_API_H
#include "device.h"
#if DEVICE_SLEEP
#ifdef __cplusplus
extern "C" {
#endif
/** Send the microcontroller to sleep
*
* The processor is setup ready for sleep, and sent to sleep using __WFI(). In this mode, the
* system clock to the core is stopped until a reset or an interrupt occurs. This eliminates
* dynamic power used by the processor, memory systems and buses. The processor, peripheral and
* memory state are maintained, and the peripherals continue to work and can generate interrupts.
*
* The processor can be woken up by any internal peripheral interrupt or external pin interrupt.
*
* @note
* The mbed interface semihosting is disconnected as part of going to sleep, and can not be restored.
* Flash re-programming and the USB serial port will remain active, but the mbed program will no longer be
* able to access the LocalFileSystem
*/
void sleep(void);
/** Send the microcontroller to deep sleep
*
* This processor is setup ready for deep sleep, and sent to sleep using __WFI(). This mode
* has the same sleep features as sleep plus it powers down peripherals and clocks. All state
* is still maintained.
*
* The processor can only be woken up by an external interrupt on a pin or a watchdog timer.
*
* @note
* The mbed interface semihosting is disconnected as part of going to sleep, and can not be restored.
* Flash re-programming and the USB serial port will remain active, but the mbed program will no longer be
* able to access the LocalFileSystem
*/
void deepsleep(void);
#ifdef __cplusplus
}
#endif
#endif
#endif