/* * Driver for BH1750 light sensor * * Part of esp-open-rtos * Copyright (C) 2017 Andrej Krutak * BSD Licensed as described in the file LICENSE * * ROHM Semiconductor bh1750fvi-e.pdf */ #ifndef EXTRAS_BH1750_H_ #define EXTRAS_BH1750_H_ #include #include #include #ifdef __cplusplus extern "C" { #endif /* Possible chip addresses */ #define BH1750_ADDR_LO 0x23 // ADDR pin floating/low #define BH1750_ADDR_HI 0x5c /* Configuration options */ // No active state #define BH1750_POWER_DOWN 0x00 // Wating for measurement command #define BH1750_POWER_ON 0x01 // Reset data register value - not accepted in POWER_DOWN mode #define BH1750_RESET 0x07 /* Measurement modes */ #define BH1750_CONTINUOUS_MODE 0x10 #define BH1750_ONE_TIME_MODE 0x20 // Start measurement at 1 lx resolution (measurement time typically 120ms) #define BH1750_HIGH_RES_MODE 0x00 // Start measurement at 0.5 lx resolution (measurement time typically 120ms) #define BH1750_HIGH_RES_MODE2 0x01 // Start measurement at 4 lx resolution (measurement time typically 16ms) #define BH1750_LOW_RES_MODE 0x03 /* Adjust measurement time to account for optical window size (see datasheet). * Procedure from datasheet suggests order Hi, Low and finally measurement mode */ #define BH1750_MEASURE_TIME_HI(mt) (0x40 | (((mt) >> 5) & 0x7)) #define BH1750_MEASURE_TIME_LO(mt) (0x60 | ((mt) & 0x1f)) #define BH1750_DEFAULT_MEASURE_TIME 0x45 /** * Configure the device. * @param addr Device address * @param mode Combination of BH1750_* flags * * May be called multiple times e.g. to configure the measurement time and * the readout mode afterwards - or if one time mode is used consecutively. * * Example: BH1750_ADDR_LO, BH1750_CONTINUOUS_MODE | BH1750_HIGH_RES_MODE */ void bh1750_configure(uint8_t addr, uint8_t mode); /** * Read LUX value from the device. * * @param addr Device address * @returns read value in lux units */ uint16_t bh1750_read(uint8_t addr); #ifdef __cplusplus } #endif #endif /* EXTRAS_BH1750_H_ */