Fix sdk_system_rtc_mem_write and sdk_system_rtc_mem_read,
the functions did not use the user-provided offsets to rtc_mem.
Without using offset, rboot's rtcdata access, and its
temp_rom handling were broken.
Also code for sdk_cnx_sta_leave, although disabled due to accessing static date, but it shows a reference to the netif->flags and the NETIF_FLAG_DHCP flag removed in lwip v2.
Function sdk_eagle_auth_done accesses the netif-flags and the NETIF_FLAG_DHCP flag removed in lwip v2, and also the netif->ip_addr so is needed for lwip development.
Function sdk_wpa_config_bss accesses the netif->hwaddr.
Also code for a few other trivial functions that help debug the dhcpc paths.
The function sdk_wifi_station_start is one of two paths that allocates a lwip struct netif and also accesses the netif->hwaddr slot so this is required for lwip development.
Also code for sdk_wifi_station_stop and sdk_sta_status_set to better understand the status state.
Add source code for functions touching the struct netif to better support lwip development: sdk_wifi_get_ip_info, sdk_wifi_set_ip_info, sdk_wifi_get_macaddr, sdk_wifi_set_macaddr.
Also code for sdk_wifi_station_get_connect_status.
Also code for wifi_get_sleep_type and set_sleep_type, noting wifi_set_sleep_type returns a bool success flag, and implement wifi_get_sleep_type using sdk_pm_get_sleep_type.
Also comment the point at which the bus clock that drives the uart changes on startup and comment out the change in the uart divisor. This at least allows a consistent uart baud rate during a restart if using the rate 115200.
* wifi_set_sleep_type returns a bool success flag.
* wifi_get_sleep_type seemed useless, just returning an argument. Added an implementation using sdk_pm_get_sleep_type.
Fixes#147
* Can vary tick rate from 100Hz via configTICK_RATE_HZ. Note that the
SDK binary libraries are hard-coded to assume the tick rate is 100Hz,
so changing the tick rate may have unexpected consequences for lower
layer WiFi behaviour (such as certain kinds of timeouts happening
faster/slower.)
* Setting configCPU_CLOCK_HZ to 160MHz means ESP will set 160MHz during
initialisation. Only 80MHz and 160MHz are supported.
* Timing of tasks is no longer affected by current CPU freq (whether set
via configCPU_CLOCK_HZ or via sdk_system_update_cpu_freq().)
Previously doubling the CPU frequency would double the tick rate.